We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › SpaceClaim stops sharing topology › Reply To: SpaceClaim stops sharing topology

October 10, 2024 at 9:03 am
Deepak
Ansys Employee

Hi,

Does the middle part have a shared topology with other parts?

To address the issue of topology sharing stopping when you change the angle parameter in SpaceClaim, it's important to ensure that the parameter changes do not disrupt the geometry in a way that would break the shared topology.

Thanks,

Deepak