We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › How to import fiber orientation analyzed in Moldflow 21 into LS-DYNA? › Reply To: How to import fiber orientation analyzed in Moldflow 21 into LS-DYNA?

October 10, 2024 at 7:07 am
zxhurs
Subscriber

Hello Reno, 

Thank you very much for the information. I am currently writing an email to Mr. Liebold. Unfortunately, there is no corresponding interface. I don’t want to waste my previous efforts. I would like to ask, besides Moldflow, would other software like Moldex3D provide the effect I hope for? Or should I just rely on Envyo?

Thanks！😊