We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › ICFD time step not followed in FSI in R13.1 › Reply To: ICFD time step not followed in FSI in R13.1

September 11, 2024 at 3:11 pm
arnau994
Subscriber

Hello,

I just find out that the initial dt set in *CONTROL_IMPLICIT_GENERAL was the cause of the issue. However, this parameter was also set at 0.1s in the R11 model, so I understand that the R13 model for some reason prioritises it instead of the *ICFD_CONTROL_TIME dt.

I will set this forum entry as solved. Sorry for any inconvenience.