We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › How to perform a strength analysis of 3D printed parts › Reply To: How to perform a strength analysis of 3D printed parts

September 3, 2024 at 5:42 am
Devendra Badgujar
Forum Moderator

Hello, 

You can perform structural simulation in Ansys Discovery. Here is the Discovery Quick Tip- Applying Physics Boundary Conditions to Faceted Geometry - Ansys Knowledge 

Regards,

Devendra