We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Block Recording in Sheet Metal › Reply To: Block Recording in Sheet Metal

August 21, 2024 at 5:17 am
Devendra Badgujar
Forum Moderator

Hello Fabian, 

Block recording is not available for sheet metal. We will forward the enhancement with the product development team. This is more likely to be added in Discovery than SpaceClaim in future.  

Regards, 

Devendra