We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Error Importing SLM Build File into Additive Print › Reply To: Error Importing SLM Build File into Additive Print

August 7, 2024 at 12:47 pm
Ashish Khemka
Forum Moderator

Hello,

I am not an expert in this area but please see if the following link helps: 6.5. Using Variable Layer Height (ansys.com)

Regards,

Ashish Khemka