Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Simplorer-Maxwell Cosimulation: [error] Cannot compute tangential sign › Reply To: Simplorer-Maxwell Cosimulation: [error] Cannot compute tangential sign
August 2, 2024 at 2:21 pm
HDLI
Ansys Employee
Hello Paul,
   Please double check if Maxwell model could run sucessfully. For co-simulation, please review https://innovationspace.ansys.com/forum/forums/topic/simplorer-co-simulation/ too to make your setting is correct. Could you share your Simplore schematic? Do you have other error message? Is this error message in Maxwell model? Thanks.
HDLI
Â