We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Getting the error while performing a fracture analysis › Reply To: Getting the error while performing a fracture analysis

July 31, 2024 at 7:14 am
Sanjay Vishwakarma
Subscriber

Thanks for your reply Sir,

I have attached more pictures of the contact pairs and the fracture zone. As u discussed that the contact area should not overlap at all with the fracture zone but in my problem the crack is at the contact zone (under the crack zone body there is another body witch is in the frictional contact as shown in the figure). 

The error was still comming it is not solved. i have attached the picture from the solution information where first the warining comes after that error come.

how to resolve this problem, please help me this.

Â