We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › Setting up units in nCode when importing d3plot › Reply To: Setting up units in nCode when importing d3plot

July 22, 2024 at 9:12 pm
javat33489
Subscriber

Thanks for your reply Sir.
In drilling tool analysis I am interested in stress and temperature and then fatigue.
Yes Sir, in LS-Dyna I use GPA and in nCode I also set GPA.