We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › DPM injection flow rates › Reply To: DPM injection flow rates

July 22, 2024 at 8:12 pm
Zwernjayden
Subscriber

 

It is steady state, and when I tracked the injected mass, it started at 0, jumped up to the expected value, then dropped back to zero after a few iterations and stayed there. And yes I made sure both where in kg/s

Â