We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Error in ‘Mechanical Application’ with Geometry from ‘Design Modeler’ › Reply To: Error in ‘Mechanical Application’ with Geometry from ‘Design Modeler’

July 20, 2024 at 7:09 pm
Gary_S
Ansys Employee

In DM, Try to connect just a few pieces. 
Then, take into Mechanical and do a simple Structural analysis or a Modal analysis. 
See if you are able to get a successful run.