We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › I am getting the error: ‘One or more faces with map mesh controls failed to be m › Reply To: I am getting the error: ‘One or more faces with map mesh controls failed to be m

July 14, 2024 at 7:28 pm
peteroznewman
Subscriber

Hello Faith, 

The message is a warning.  It may not have been triggered on the older version of Ansys the course was recorded in. You should be able to proceed with the simulation by suppressing Face Meshing. I have some experience with stent expansion simulations if you need more help.

Regards,

Peter