We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › How to define inlet and outlet on complex geometry › Reply To: How to define inlet and outlet on complex geometry

July 13, 2024 at 4:12 pm
Daniel Grafton
Subscriber

Thanks a lot Peter! very helpful 

Do i have to convert my shape to geometry first using auto skin  ? 

Otherwise when I split shape like in the video i just get a hole into the hollow shape, or if i cap the hole, it caps with a lot of facets again (see pics below).