Ansys Learning Forum › Forums › Installation and Licensing › Ansys Products › Poor quality mesh at trailing edge for 3d wing › Reply To: Poor quality mesh at trailing edge for 3d wing

July 9, 2024 at 4:48 pm
Purnima Janjanam
Subscriber

The mesh goes like this somewhere in the middle even when the sizing settings are set to hard. Can you tell me what can i do to make it better. 

If I decrease size the number of nodes will increase and my cluster cannot handle it to run the simulation. so I'm trying to limit my number of nodes by limiting the size.

I expect the flow between to airfoils to oscillate. But I was trying to find a single result if I could get one. This is more of experimenting to understand what's happening.