We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › SpaceClaim driving parameters › Reply To: SpaceClaim driving parameters

June 3, 2024 at 12:48 pm
Haha
Subscriber

Hi,

 

This is my new link design.

Essentially, the assembly settings involve first using "Align" to center, followed by "Tangent" to make the contact surfaces tangential.Thank you.