We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Dimension optimization › Reply To: Dimension optimization

May 24, 2024 at 6:45 am
Charudatta Bandgar
Forum Moderator

Hello jakub,

You can try doing that in Discovery. Please find this knowledge article on how you can parameterize your geometry: Discovery Explore Mode - Performing Parameter Sweep Study - Ansys Knowledge