We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Importing wind turbine blade profile geometry › Reply To: Importing wind turbine blade profile geometry

May 10, 2024 at 1:25 pm
Devendra Badgujar
Forum Moderator

Hi, 

I will have to check if this is possible, and get back to you on this. 

Regards,

DevendraÂ