We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › (Rolling) Sheet thickness after rolling doesn’t match the roller’s gap › Reply To: (Rolling) Sheet thickness after rolling doesn’t match the roller’s gap

April 26, 2024 at 4:07 pm
sgkcompany
Subscriber

Sorry I still get little confused
here is my current setting
1 for roll to roll back roll is target ; work roll is contact
2 for roll to plane work roll is contact ; sheet is target

You said I need 2 contacts for roll to plate but I only need 1 there.