We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › Beam-to-Beam Contacts › Reply To: Beam-to-Beam Contacts

April 15, 2024 at 1:24 pm
Alex R.
Ansys Employee

Hello Thomas, 

In your contact SURFATYP = 3 means a single part, PID = 1. In your case you should use SURFATYP = 2 Part set ID. 

Please try *CONTACT_AUTOMATIC_GENERAL. 

Thanks,
AlexÂ