We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Need help with UDF. “999999: mpt_accept: error: accept failed: No error.” › Reply To: Need help with UDF. “999999: mpt_accept: error: accept failed: No error.”

April 15, 2024 at 10:10 am
Rob
Forum Moderator

We'd normally use DEFINE_PROFILE to set boundary conditions. Is this for a transient flow?