We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Doubt About Y Plus Value for Simulations › Reply To: Doubt About Y Plus Value for Simulations

April 11, 2024 at 10:42 am
Ashen Perera
Subscriber

I actually check the meshing parameters , residual convergence and the monitor points.

just confused about why I am easily able to get it down to low values but I am unable to increase the y plus much.Â