We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Inconvergence error in Transient Structural › Reply To: Inconvergence error in Transient Structural

March 14, 2024 at 5:21 am
ritesh singh
Subscriber

 

thanks for the reply. i have tried the model with coarser grain struture of 4mm hexahedral element and as shown in attached image. it is showing results. but when i increase heat input from 300 to 838, it is again showing convergence error. At heat input of 300, peak temp is reaching 960 C approx. At heat input of 838 peak temperature reaching is approx 3000 C (although it is 800 C greater than expected), for the same mesh arrangement. kindly help. (its been 4 months since i am working on this convergence issues). all the boundary conditions and the materials are same as in previous posts.

Â