We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › 4 point bending test of RC Beam — Convergence Issues › Reply To: 4 point bending test of RC Beam — Convergence Issues

March 14, 2024 at 4:49 am
Rommel Jr. Landicho
Subscriber

Hi again sir! My model is now converging thanks to the command snippet 

TB,CONCR,matid,,,MSOL
TBDATA,1,2,1,1e-3,100,10,1e-20

However, I am not sure what these values correspond to. Can someone please explain what this command does? 

Thanks!