We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › effetive stress vs strain curve not as expected › Reply To: effetive stress vs strain curve not as expected

March 13, 2024 at 3:25 pm
Jim Day
Ansys Employee

NIP=3 should also work.   Just be sure to set MAXINT=3 if ELFORM=2 and if ELFORM=16, because there are 4 in-plane integration points, set MAXINT= -3 so that data for each integration point is output to d3plot.