We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Preprocessing › Multizone meshing issue › Reply To: Multizone meshing issue

February 10, 2024 at 12:19 am
mjmiddle
Ansys Employee

Can you zoom in to one of these regions to actually see the elements? Whta direction is the sweep? Top to bottom?

Cna you show a section pane through one of these regions showing all mesh?