We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Scoping boundary condition to ‘Point mass’ › Reply To: Scoping boundary condition to ‘Point mass’

January 24, 2024 at 9:14 pm
peteroznewman
Subscriber

Acceleration loads are applied to all mass in the model.  They are not scoped to individual bodies.  It doesn't matter where the label for the acceleration shows up.

APDL and Workbench both support an Acceleration load.