We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Transient Analysis Residual Vibration › Reply To: Transient Analysis Residual Vibration

November 23, 2023 at 8:11 am
gioele esposto alessi
Subscriber

Hello,

 I applied a face shift that I had set as fixed supports, specifically the shift is 5 meters in 0.1 seconds. I would therefore expect to see a residual vibration given by this acceleration, but this does not happen and I do not understand why.

Thank you for your reply