We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Creation of Periodic B.C in ICEM › Reply To: Creation of Periodic B.C in ICEM

November 20, 2023 at 5:42 pm
Aras karimi
Subscriber

Hi Dear mjmiddle,

I want to create mesh and periodic boundary condition for another mode.

This time, the front page of the flow is at  Z= -0.7mm  and the back page of the flow is at   Z= -40.7mm. That is, the length of the airfoil span is 40mm.

What number should I put for the offset?