We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Showing Normal Stresses with LCS Issue › Reply To: Showing Normal Stresses with LCS Issue

November 20, 2023 at 2:08 pm
josh dudman
Subscriber

 

I managed to answer my question. It was on an assembly with 3D and 2D geometry and when the default all bodies was selected the LCS was yellowed out. But when I scoped to just the 3D bodies it worked fine.

Â