Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Creation of Periodic B.C in ICEM › Reply To: Creation of Periodic B.C in ICEM

November 18, 2023 at 3:42 pm
Aras karimi
Subscriber

Hi Dear mjmiddle,

I want to create mesh and periodic boundary condition for another mode.

This time, the front page of the flow is at   Z= -0.7mm   and the back page of the flow is at   Z= -40.7mm. That is, the length of the airfoil span is 40mm.

What number should I put for the offset?