We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Installation and Licensing › Ansys Products › Ansys workbench not working with Ansys mechanical 2022 R1 › Reply To: Ansys workbench not working with Ansys mechanical 2022 R1

September 27, 2023 at 3:29 am
Adel Ameer
Subscriber

Hi,

I have the same problem when I try to open the model that was created in Geomtery it gives this message as shown below. Can anyone help, please?

Â