We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Assingment stress slip Curve for contact between Acnchor and Concrete › Reply To: Assingment stress slip Curve for contact between Acnchor and Concrete

July 15, 2023 at 10:48 am
Quantum
Subscriber

Hello all,

I have a question and I will appreciate any answer

I have this case and I want to enter the stress slip curve for the contact area between the concrete and the anchor because i want to test the failure load of pull aut test 

 How can I doing that in Ansys Workbench

I have created an new material and  Bond stress through CMZ defined

But I still don’t know how to assign this material to the contact region



Regards