We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Installation and Licensing › Ansys Products › Writing Injection files for DPM › Reply To: Writing Injection files for DPM

July 5, 2023 at 7:54 pm
Salix Bair
Subscriber

Here is my injection file: 

 

(injection 12)
(          x           y            z            u            v            w     diameter            t    mass-flow         mass    frequency         time         name)
(( 1.0000e-02   6.0000e-04   0.0000e+00   2.0000e+00   0.0000e+00   0.0000e+00   1.0000e-08   3.0000e+02   1.0000e-20   5.2266e-22   1.9133e+01    0.0000e+00) r=1mm:0)
(( 1.0000e-02   6.0000e-04   0.0000e+00   2.0000e+00   0.0000e+00   0.0000e+00   4.5426e-08   3.0000e+02   1.0000e-20   4.8991e-20   2.0412e-01    0.0000e+00) r=1mm:1)
(( 1.0000e-02   6.0000e-04   0.0000e+00   2.0000e+00   0.0000e+00   0.0000e+00   1.1628e-07   3.0000e+02   1.0000e-20   8.2166e-19   1.2170e-02    0.0000e+00) r=1mm:2)
(( 1.0000e-02   6.0000e-04   0.0000e+00   2.0000e+00   0.0000e+00   0.0000e+00   1.0019e-06   3.0000e+02   1.0000e-20   5.2566e-16   1.9024e-05    0.0000e+00) r=1mm:3)
(( 1.0000e-02   6.0000e-04   0.0000e+00   2.0000e+00   0.0000e+00   0.0000e+00   4.2611e-06   3.0000e+02   1.0000e-20   4.0436e-14   2.4730e-07    0.0000e+00) r=1mm:4)

Getting this error: 

Error: CAR: invalid argument [1]: wrong type [not a pair]

Error Object: injection