We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Issue with MagFlux Magnetostatic Report in ANSYS Maxwell › Reply To: Issue with MagFlux Magnetostatic Report in ANSYS Maxwell

June 29, 2023 at 1:56 pm
jksince1996
Subscriber

 

 

Info: I’m modeling a single-phase transformer in an air domain. It has a ferrite core, copper windings, and a plastic bobbin. The current excitation is AC with a frequency of 200 kHz and an amplitude of 75 A. I’ve defined a mesh for the core and one for the windings.

Version: Ansys Electronics Desktop 2023 R1

Solver: Transient

I am now unable to plot several quantities such as inductance and field overlays such as the B field, etc. Loss plots show up. So do design plots. Winding plots other than inductance such as flux linkage show up too. The order of magnitude of some of the quantities are off too.

How can this be resolved? Thanks!

 

Â