We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › One or more objects may have lost some scoping attachments during the › Reply To: One or more objects may have lost some scoping attachments during the

March 20, 2023 at 7:25 pm
Divya Giri
Subscriber

Hi Nanda,

Thank you for your reply. I rechecked the model where I had scoped the geometry. But I am encountering another problem during the simulation. Solution information shows crack front does not have a contiguous set of nodes. The meshing and crack generation was although successful. I have no clue how to resolve this error.

Best Regards,

Divya Giri

Â