We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Please check for an insufficiently constrained model › Reply To: Please check for an insufficiently constrained model

February 22, 2023 at 12:38 am
H Nor
Subscriber

i made the element individually by solid65 for the whole beam column joint. which then i created new element of link180 for the rebar and stirrups and applied it at the existing nodes.