Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Spur gear stress analysis › Reply To: Spur gear stress analysis
September 21, 2022 at 7:53 pm
fab88
Subscriber
Actually, I had forgotten to apply a remote displacement on the driven gear. But now, it is working.
Here are my BCs.
Also, I had to include in weak springs to avoid rigid body motion.Â
Now, I am facing another problem. When I am trying to allow full rotation (360) of the cut gears, the solution fails to solve. Let's say, I want 10 revolutions.
Â
I mean after this time.
What can I do?
Thanks.