We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › non-zero boundary condition on the wall › Reply To: non-zero boundary condition on the wall

September 19, 2022 at 8:43 am
eric1234598765
Subscriber

Hi,

What's the boudnary type of the bottom plate? If it is a interface, then choosing couple option in the mesh interface setting in Fluent could treat that boudnary as impermeable wall.

Otherwise, it is strange that Fluent can not set a no slip condition on a wall boudnary.

Eric