Ansys Learning Forum › Forums › Installation and Licensing › Ansys Products › Ansys Motor CAD software goes into not responding mode after running E-magnetic/Lab/Mech module. › Reply To: Ansys Motor CAD software goes into not responding mode after running E-magnetic/Lab/Mech module.
October 27, 2021 at 8:17 pm
George Karnos
Ansys Employee
avdhutcsabnis
If this is an Enterprise license, a Service Request should be logged on the Customer Portal.
https://support.ansys.com/
If this is an Enterprise license, a Service Request should be logged on the Customer Portal.
https://support.ansys.com/