Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Multiple Static Load Steps in APDL Editor › Reply To: Multiple Static Load Steps in APDL Editor
July 22, 2021 at 3:21 pm
Govindan Nagappan
Ansys Employee
You are solving for time=2 without changing the load. So the load stays at 0.5
Instead, for load step2, set time to 3
define your load and solve
!load step2
time,3
DCUM,....
Or consider defining a table to apply the load
Instead, for load step2, set time to 3
define your load and solve
!load step2
time,3
DCUM,....
Or consider defining a table to apply the load