Ansys Learning Forum › Forums › Discuss Simulation › Fluids › How to create the particles bed from coordinates and radii in Selective Laser Melting? › Reply To: How to create the particles bed from coordinates and radii in Selective Laser Melting?
July 23, 2021 at 8:47 am
Rob
Forum Moderator
I'm not sure I quite understand the question.
The adaption registers aren't a separate cell zone, they're marked cells to then patch in the "solid" material that will melt. If the spheres are smaller than the cells you'll not mark anything. To view the marked spheres use the Display option in the Adaption tool, or the solid/liquid fraction on the contours.
The adaption registers aren't a separate cell zone, they're marked cells to then patch in the "solid" material that will melt. If the spheres are smaller than the cells you'll not mark anything. To view the marked spheres use the Display option in the Adaption tool, or the solid/liquid fraction on the contours.