Physics Setup — Lesson 3

The following video describes the procedure for setting up

  1. Interfaces
  2. Transient solver
  3. Mesh Motion

Text summary of the above video
  • Open Fluent from Solution.
  • If the Mesh Interfaces are gone, recreate them as was done in Part 1.
  • Check that the Boundary Conditions were correctly copied.
  • Under "General," change the Solver to Transient.
  • Under Cell-Zone Conditions...
    • Highlight "inner." Click Edit. Copy to Mesh Motion. Check that everything has been transferred.
    • Do the same thing for the other 3 blades.