Course Assessment: Rocky Tutorial – Dam Break
Quiz Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
-
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
-
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
-
Congratulations you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
-
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
Which geometry was not used in this tutorial?
-
Question 2 of 10
2. Question
Which was the fluid simulated?
-
Question 3 of 10
3. Question
Which was the movement used for the gate?
-
Question 4 of 10
4. Question
Why was it needed to define a custom boundary box that exceeds the limits of the walls’ geometries?
-
Question 5 of 10
5. Question
Which was the enabled module for this simulation?
-
Question 6 of 10
6. Question
Which were the main parameters evaluated in this lesson?
-
Question 7 of 10
7. Question
Which kind of solution was visualized?
-
Question 8 of 10
8. Question
What does a 0-weight property mean for a specified region?
-
Question 9 of 10
9. Question
When and where did the maximum force occur during the simulation?
-
Question 10 of 10
10. Question
In which axis was the force evaluated?