Course Assessment — Induction Motor Design using Ansys Motor-CAD Sensitivity Analysis
Quiz Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
-
Unfortunately, you did not pass the quiz.
Don't be discouraged - Go through the course material including the lecture videos, handout slides, and simulation examples to prepare and try again.
-
Congratulations, you have passed the quiz!
You still have room for improvement - Review the slides and simulation examples again to identify the concepts that you may have missed.
-
Congratulations, you have passed the quiz!
You scored better than average, but if you are still unsure about a particular topic, try starting a discussion on the Ansys Learning Forum to discuss your questions with peers around the world.
-
Congratulations you have passed the quiz!
You did great - Check out other courses to further your knowledge. Also, visit the Ansys Learning Forum and participate in discussions on this subject to help your peers and deepen your own knowledge.
-
Congratulations you have passed the quiz!
You have excelled on this topic - Check out other courses and see if you can ace them too. Also, visit the Ansys Learning Forum to help your peers on this topic. With your knowledge, you can make a real difference.
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
In order to start the design by Ansys Motor-CAD sensitivity analysis tool all dimensions need to be a ratio of stator outer diameter exclusively.
-
Question 2 of 10
2. Question
In the radial geometry tap, “Geometry Parameterisation” should be set to ______ to include the stator number of slots as a parameter in the sensitivity analysis.
-
Question 3 of 10
3. Question
According to the proposed design method in the course, which of the following values are needed before the design process (select all applicable choices):
-
Question 4 of 10
4. Question
The main parameters of a motor design are stator outer diameter, axial length, and number of turns.
-
Question 5 of 10
5. Question
If output mechanical power is zero for motor design, this means that _______ . (select all applicable choices):
-
Question 6 of 10
6. Question
Which of the following parameters is not included in the sensitivity analysis and should be selected by the user? (select all applicable choices):
-
Question 7 of 10
7. Question
In the first stage of design process we select the valid design based on the values of efficiency and maximum flux density.
-
Question 8 of 10
8. Question
If the total weight of motor is much greater than the summation of motor parts in EM mode, this means that:
-
Question 9 of 10
9. Question
Python codes used in this course are used to ____________ . (select all applicable choices):
-
Question 10 of 10
10. Question
The Ansys Motor-CAD Lab mode is used for advanced optimization.