Times up!
Antenna Toolkit — Theory Quiz
Once you have finished the exam, click on the 'Mark Complete' button to save your progress and move to the next section.
1 / 10
Which of the following is correct when "Enable material override" option is checked under Design Settings in Ansys Electronics Desktop?
2 / 10
Which parametric sweep can be performed inside of Ansys Electronics Desktop?
3 / 10
What are the patch dimensions with following given parameters?Center frequency = 2.4 GHz, Radiation boundary, Material FR4 epoxy, Substrate height = 0.8 cm (Use ACT Extension to get the result)
4 / 10
What would be the length of the wire dipole antenna for 2.4 GHz frequency with radiation boundary condition using Antenna toolkit in Ansys Electronics Desktop?
5 / 10
What is the purpose of placing a radiating element in a radome?
6 / 10
What is the input impedance of a half wave dipole antenna?
7 / 10
Which parameter is used to measure the antenna performance?
8 / 10
What is the selection sequence to add a parametric setup to a design in Ansys Electronics Desktop?
9 / 10
Which of the following will be created when an antenna design is created using Antenna Toolkit ACT extension in Ansys Electronics Desktop?
10 / 10
Which is the correct path to access the Antenna Toolkit in Ansys Electronics Desktop?
Your score is
